4
SEALANT |
NEOPRENE |
SEAL |
INSTALL NEOPRENE OR GRAPHITE FELT SEAL*
Install seal evenly around waste flange (horn). Apply a thin bead of sealant around base flange.
*Note: Wax seal not recommended for this application.
5 |
| |
FLANGE | FLANGE | |
BOLTS | ||
| ||
LAG |
| |
BOLT |
| |
TAPERED |
| |
WASHERS |
|
INSTALL TOILET ON FLANGE
a.Unplug wall waste opening and slide toilet towards closet flange so bolts project through mounting holes.
b.Loosely install retainer tapered washers and nuts. Side of washers marked "THIS SIDE UP" must face you!
6
BOLT
CAP
NUT & |
|
WASHER |
|
| BOLT |
| CAP |
WASHER | BOLT HEAD |
INSTALL TOILET
a.Position toilet squarely to wall and, with a rocking motion, push bowl against ring and flange.
Alternately tighten nuts until toilet is firmly anchored.
!CAUTION: DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b.Insert the tapered washers (supplied in the kit) into the
lag bolts (not supplied). Insert bolts through mounting holes and tighten into
c.Install the four bolt caps on tapered washers. (If necessary, cut wall bolt length to size before installing caps.)
d.Smooth off the bead of sealant around base. Remove excess sealant.
7
TANK MTG. | SPONGE |
WASHER | |
BOLTS |
|
WASHER
NUT
INSTALL TANK
a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening, and tank mounting bolts go through mounting holes. Secure with metal washers and nuts.
b.With tank parallel to wall, alternately tighten nuts until tank is snugged down evenly against bowl's sanitary ribs.
!CAUTION: DO NOT OVERTIGHTEN
NUTS MORE THAN REQUIRED
FOR A SNUG FIT!
8INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.
- 2 - |