Preparing to Install into a Matrix E7, N1, N3, N5, or N7 Chassis

Installing the 7H4385-49 into Matrix N1, N3, or N5 Chassis

Caution: Failure to observe static safety precautions could cause damage to the module. Follow static safety handling rules and wear the antistatic wrist strap.

Do not cut the non-conductive bag to remove the module. Sharp objects contacting the board or components can cause damage.

Precaución: Si no toma las medidas de seguridad necesarias para evitar descargas de electricidad estática, es posible que el módulo se dañe. Siga los consejos de seguridad para la manipulación del producto y no olvide utilizar la pulsera antiestática.

No corte la bolsa antiestática para sacar el módulo. Tenga en cuenta que si algún objeto cortante entra en contacto con la placa o con los componentes, éstos podrían dañarse.

A DFE module can be installed in any available chassis slot (1 through 3) in the Matrix N3 chassis, or slots 1 through 5 in the Matrix N5 chassis, or into the single slot of the Matrix N1 chassis. All chassis have horizontal slots for DFE modules. To install the module into the Matrix N3, N5, or N1 chassis, refer to Figure 3‐3 and proceed as described in “Preparing to Install into a Matrix E7, N1, N3, N5, or N7 Chassis” on page 3‐7.

1.Prepare the DFE module using the procedure described in “Preparing to Install into a Matrix E7, N1, N3, N5, or N7 Chassis” on page 3‐7.

Caution: When setting the locking levers to the closed position, do not try to force the locking levers to the point that they touch the face of the front panel. Forcing the locking levers to this point could damage the module and chassis.

Precaución: Al mover las palancas a la posición de cerrado, tenga cuidado de no llevarlas a un punto en donde estén en contacto con el panel frontal. Si lo hace, podría dañar el módulo o el chasis.

Electrical Hazard: To prevent exposure to an energy hazard in a 7H4385-49 connected to an external N-POE Power System, disconnect the 48-Vdc power cable from the 48-Vdc input connector before servicing or removing the 7H4385-49.

Riesgo Eléctrico: Para prevenir la exposicion a un riesgo electrico en una tarjeta 7H4385-49 conectada a un sistema externo de energia N-POE Power System, desconectar el cable de poder de 48-Vdc del conector de entrada 48-Vdc antes de dar servicio o remover la tarjeta 7H4385-49.

Elektrischer Gefahrenhinweis: Um den Schutz vor el. Schäden des Moduls

(7H4385-49) zu gewähleisten, bei Verwendung der N-POE Systeme, sollte dies bevor man dieses entnimmt oder Servicearbeiten daran vornimmt, vom 48-Vdc Stecker getrennt werden.

2.Locate the chassis card guides that line up with the slot number in which the module will be installed. Make sure the module locking levers are in the open position (top and bottom).

DFE-Platinum Series Hardware Installation Guide 3-11

Page 41
Image 41
Enterasys Networks manual Installing the 7H4385-49 into Matrix N1, N3, or N5 Chassis