Enterasys Networks 7H4385-49 manual RX/TX Indications in Standard Mode

Using LANVIEW

Table 4-1 LANVIEW LEDs (continued)

LED Color State Recommended Action

CPU	Amber and Alternating (67% on, 33%
(cont’d)	off	off). Indicates that a
		shutdown process has
		completed. This indication

will remain for 60 seconds before automatically restarting.

While in this state, you have 60 seconds to safely remove the DFE module from the chassis.

RX/TX Indications in Standard Mode

RX	Off	No link. No activity. Port	None.
(Receive)		enabled or disabled.
	Green	Solid. Link present, port	None.
		enabled, no traffic is being
		received by the interface.
	Amber	Flashing. Link present, port	None.
		enabled, traffic is being
		received by the interface.
	Red	Blinking. Indicates	Contact Enterasys Networks for
		collisions. This indication is	technical support.
		only supported on 10/100
		ports.
TX	Off	Port enabled, but no activity.	If it is known that the port should be
(Transmit)			active and is not, contact
			Enterasys Networks for technical
			support.
	Green	Flashing. Indicates data	None.
		transmission activity. Rate of
		flashing indicates the data
		rate.
	Red	Flashing. Fault or Error	None, unless there is a high rate of
		(collision).	activity. In this case, check for network
			configuration problems or a defective
			device.

4-4 Troubleshooting