Gaining Access to Memory Modules

Installing the DIMM

Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive electronic equipment.

Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones de seguridad para evitar descargas de electricidad estática.

To install a DIMM, refer to Figure B‐8 and proceed as follows:

1.Insert the DIMM down between the connector fingers.

2.Pivot the DIMM downward so the tabs on the connector arms align with the two alignment notches. With the two connector arms spread outward, push the DIMM down between the connector arms. Then release the two connector arms to lock the DIMM into place.

3.Reinstall the safety cover. Refer to “Reinstalling the Safety Cover” on page B‐13 for instructions.

Figure B-8 Installing the DIMM

Ã

 

 

Â

À

 

 

 

 

 

 

Ã

 

 

Á

Â

 

 

 

1

DIMM

3

Connector arms

2

Connector fingers

4

Alignment notches (2)

Installing the Network Expansion Module (NEM)

Refer to Figure B‐9 and proceed as follows:

1.Position the NEM so its front panel is under the edge of the DFE module front panel.

2.Align the two NEM connectors with the main board connectors. Then press straight down over the two NEM connectors, applying pressure until they are properly seated.

DFE-Platinum Series Hardware Installation Guide B-11

Page 83
Image 83
Enterasys Networks 7H4385-49 manual Installing the Network Expansion Module NEM, Installing the Dimm