Using LANVIEW

3.Press the GROUP SELECT button again for more than one second. This returns the 7H4385‐49 to the default status mode to monitor RX (receive) and TX (transmit) activity.

Table 4‐1 describes the LED indications and provides recommended actions as appropriate.

Note: The terms used in Table 4-1indicate the following:

Flashing indicates LED is flashing randomly.

Blinking indicates LED is flashing at a steady rate (approximately 50% on, 50% off).

Solid indicates a steady LED light. No pulsing.

Alternating indicates LED is flashing in a steady rate other than 50% on, 50% off.

Table 4-1 LANVIEW LEDs

LED

Color

State

Recommended Action

 

 

 

 

MGMT

Off

Off. This DFE module is NOT

None.

 

 

the Management Module.

 

 

 

 

 

 

Green

Solid. This module is the

None.

 

 

designated Management

 

 

 

Module.

 

 

 

 

 

 

Amber

Flashing. This is a

None.

 

 

temporary indication that the

 

 

 

DFE module is saving data.

 

 

 

 

 

CPU

Off

Power off.

Ensure chassis has adequate power.

 

 

 

 

 

Amber

Blinking. DFE module in

None.

 

 

process of booting.

 

 

 

 

 

 

 

Solid. Testing.

If the LED remains amber for several

 

 

 

minutes, contact Enterasys Networks

 

 

 

for technical support.

 

 

 

 

 

Green

Blinking. Image starts

None.

 

 

running.

 

 

 

 

 

 

 

Solid. Functional.

None.

 

 

 

 

 

Red

Solid. Processor in reset.

None.

 

 

 

 

Green and Blinking. Indicates that the

None. This state is activated when the

 

Amber

DFE module is in the process

OFFLINE/RESET switch is pressed for

 

 

of shutting down.

less than 1 second to start the process

 

 

 

of an orderly shutdown.

While in this state, do not remove any

DFE module.

DFE-Platinum Series Hardware Installation Guide 4-3

Page 61
Image 61
Enterasys Networks 7H4385-49 manual Led, Color State Recommended Action