Enterasys Networks 7H4385-49 manual Connecting to a VT Series Terminal, Parameter Setting

Connecting to COM Port for Local Management

4.Turn on the PC and set the following parameters on your VT emulation package:

Parameter	Setting
Mode	7	Bit Control
Transmit	Transmit=9600
Bits Parity	8	Bits, No Parity
Stop Bit	1	Stop Bit

5.When these parameters are set, the Local Management password screen will display. Refer to the appropriate Enterasys Matrix DFE‐Platinum Series Configuration Guide for further information.

Figure 3-9 Connecting an IBM PC or Compatible

FAST ENET

7H4385-49

1

à  
OFFLINE/

RESET

COM

MGMT CPU POE

GROUP

SELECT

GROUP

1 1

2 2

3 3

4 4 5

6

Á

1	UTP straight-through cable with RJ45 connectors	3	RJ45-to-DB9 PC adapter
2	RJ45 COM port	4	IBM PC or compatible device

Connecting to a VT Series Terminal

To connect a VT Series terminal to an Enterasys Networks DFE module COM port

(Figure 3‐10), use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25 female adapter, and proceed as follows:

1.Connect the RJ45 connector at one end of the UTP straight‐through cable to the COM port on the Enterasys Networks module.

DFE-Platinum Series Hardware Installation Guide 3-21