Furuno GP-1850D installation manual Installation of Dgps beacon receiver

Handling of Coaxial Cable

•Do not touch the connector with bare hands; use gloves.

•Use radio pincers to remove, and pull out straightly.

•Plug in connector straightly.

3.Fasten the GR-7000A (DGPS beacon receiver) to the heat sink with four 3X8 screws as shown in the figure below.

Screws (3 X 8), 4pcs.

DGPS Beacon receiver

GR-7000A

GN-7707

Figure 4-4 Installation of DGPS beacon receiver

4. Open the cover of GR-7000A to connect two coaxial cables shown below.

J2

J1

Mini pin coax. cable

J3

Piece of shrink tubing

From GN-7707

Cable Assy.

S.FL2-2LP0.7-D-WHT (250) (Supplied with DGPS kit)

Figure 4-5 Connecting the coaxial cables in GR-7000A

5.Close the cover of GR-7000A passing the two cables out through respective notches in the cover.

6.Plug PH6P-W-L240 connector to J2 on the GR-7000A through the cover.

4-4