Furuno GP-1850D installation manual Installation of Dgps receiver, Dismounting chassis assembly

Installation of DGPS receiver

Procedure

1.Dismount chassis assembly from panel/chassis assembly by disconnecting the connector and PH8P from J8 on MAIN Board shown in the figure below.

Remove two ties (CV-100).

Chassis Assembly

PH8P

Connector

Panel Assembly

Figure 4-2 Dismounting chassis assembly

2.Dismount heat sink from chassis assembly by unfastening three screws on the ANLG board, loosening a screw at TR fixing plate and disconnecting the con- nector of the mini pin coax cable.

ANLG Board Screws (3 X 8), 3pcs.

Mini pin coax cable

Heat Sink

TR fixing plate

Figure 4-3 Chassis assembly

4-3