4 |
|
SEALANT | WAX RING |
|
INSTALL WAX SEAL
Invert toilet on floor (cushion to prevent damage), and install wax ring evenly around waste flange (horn), with tapered end of ring facing toilet. Apply a thin bead of sealant around base flange.
5
NUT
TAPERED WASHER
FLANGE
CLOSET BOLT
INSTALL TOILET ON FLANGE
a.Unplug floor waste opening and install toilet on closet flange so bolts project through mounting holes.
b.Loosely install retainer washers and nuts. Side of washers marked "THIS SIDE UP" must face up!
6
BOLT CAP
WASHERNUT
CLOSET FLANGE |
CLOSET BOLT
7
SPONGE
TANK MTG. 
WASHER
BOLTS
WASHER 
NUT 
INSTALL TANK
a. Install large rubber gasket over threaded |
outlet on bottom of tank and lower tank |
onto bowl so that tapered end of gasket |
INSTALL TOILET
a.Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange.
Alternately tighten nuts until toilet is firmly seated on floor.
!CAUTION: DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b.Install caps on washers. (If necessary, cut bolt height to size before installing caps.)
c.Smooth off the bead of sealant around base. Remove excess sealant.
| fits evenly into bowl water inlet opening, | |
| and tank mounting bolts go through | |
| mounting holes. Secure with metal | |
| washers and nuts. | |
b. With tank parallel to wall, alternately | ||
| tighten nuts until tank is snugged down | |
| evenly against bowl surface. | |
! | CAUTION: DO NOT OVERTIGHTEN | |
NUTS MORE THAN REQUIRED | ||
| ||
| FOR A SNUG FIT! | |
8INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.
730479 - 100 Rev . A | - 2 - |
