American Standard 2455, 2457 Cone Washer with, Plastic Supply Line, Install Toilet, Install Tank

6

BOLT CAP

CLOSET FLANGE

7

For Tanks/Bowls using Speed Connect System (Tank mounting bolts pre-installed).

TANK MTG.	RUBBER
	GASKET
BOLTS PRE-
INSTALLED

WASHER/

NUT

COMBO

CLOSET BOLT

WASHER NUT

INSTALL TOILET

a.Position toilet squarely to wall and, with a rocking motion, press bowl down fully on wax ring and flange. Alternately tighten nuts until toilet is firmly seated on floor.

!CAUTION:

DO NOT OVERTIGHTEN NUTS

OR BASE MAY BE DAMAGED!

b.Install caps on washers. (If necessary, cut bolt height to size before installing caps.)

c.Smooth off the bead of sealant around base. Remove excess sealant.

INSTALL TANK

a.Install large rubber gasket over threaded outlet on bottom of tank and lower tank onto bowl so that tapered end of gasket fits evenly into bowl water inlet opening, and tank mounting bolts go through mounting holes. Secure with metal washer/nut combo.

b.With tank parallel to wall, alternately tighten nuts until tank is snugged down evenly against bowl surface.

*USE INCLUDED TOOL, NUT DRIVER, OR DEEP SOCKET RACHET.

!CAUTION:

DO NOT OVERTIGHTEN NUTS MORE

THAN REQUIRED FOR A SNUG FIT!

8 INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.

9a	Before continuing, determine the type of water supply connecation you have from
	the chart below and use the appropriate assembly parts required to properly
	reconnect the water supply. DO NOT use plumber's putty to seal these fittings.

METAL / COPPER	METAL FLANGED	METAL SPIRAL		VINYL / BRAIDED
FLARED TUBING	TUBING	TUBING		CONNECTOR
LOCK NUT	LOCK NUT		LOCK NUT	LOCK NUT
CONE	EXISTING		EXISTING	COUPLING
	WASHER
WASHER			CONE	NUT
COUPLING	EXISTING		WASHER
	COUPLING		COUPLING
NUT
	NUT		NUT
WATER	WATER		WATER	WATER
SHUT-OFF	SHUT-OFF		SHUT-OFF	SHUT-OFF
These parts must be used as	Use existing	Use existing spiral		Captive cone
illustrated to insure water-tight	coupling nut	cone washer.		washers already
connection. Use of existing	and washer.	Fluidmaster cone		included. No
coupling nut may result in		washer may not		additional washers
water leakage. Water supply		seal completely on		needed.
tube or pipe must extend at		spiral type supply
least 1/2" inside threaded		line.
shank of valve (does not
apply to flanged tubing).
CAUTION: DO NOT USE			CAUTION: Overtightening of
CONE WASHER WITH			LOCK NUT or COUPLING NUT
			could result in breakage and
PLASTIC SUPPLY LINE.			potential flooding.

9b

With correct washers in place (see Step 9a), tighten COUPLING NUT 1/4 turn beyond hand tight.

DO NOT OVERTIGHTEN.

!WARNING: Do not use plumber’s putty, pipe dope, or any other sealant on the water supply connection to this tank. If the connection leaks after hand tightening, replace the supply line. If the connection continues to leak with the new supply line, replace the fill valve.

Warranty is void if any type of sealant is used on the water supply connection.

- 2 - 7301102-100 Rev. K