2 INSTALL DIVERTER
When finished tiling the wall, remove PLASTER GUARD (1). Remove two screws that secure the DIVERTER LID (2) and
remove Lid. Inspect the inside surface of diverter port. 2 Diverter port must be free of any dirt. Clean if necessary.
Install DIVERTER (3) with SCREWS (4) removed with
DIVERTER LID (2).
Operate DIVERTER (3). DIVERTER (3) should slide in and out smoothly.
Push on DIVERTER COVER (5).
DIVERTER PORT
3
4
5
1
3 INSTALL TRIM
Push CAP (1) over VALVE CARTRIDGE (2).
Mount ESCUTCHEON (3) and gasket to valve body with SCREWS (4). Remove PIPE CAPS (5) from shower pipe and tub filler pipe.
Install SHOWER ARM (6) and SHOWER HEAD (7).
CAUTION: Protect finish on SHOWER ARM, SHOWER HEAD and TUB SPOUT when installing.
6
5
INSTALL SPOUT
7
Insert SPOUT SHANK (8) through hole of MOUNTING LEDGE. Make sure that the RUBBER RING (9) is properly seated in RECESS at base of SPOUT (10).
Assemble RUBBER WASHER (11) and BRASS WASHER (12) onto SHANK (8). From underside of ledge secure SPOUT (10) into position with LOCKNUT (13).
Make pipe connections between valve body and SPOUT SHANK (8).
3
| 10 |
RECESS | 8 |
| 1/2" NPT |
| 9 |
| BATHING POOL OR |
11 | MOUNTING LEDGE. |
|
12
1
2
4
1/2" NPT
13 | 5 |
. 3 F W