Implementing Additional Configuration and Maintenance Tasks
Figure 14 Installing and Removing Flash Memory Card or Flash Disk
a
EJECT
b
SLOTSLOT | |
- | - |
0 | 1 |
AUX RESET | |
| EJECT | |
SLOTSLOT | ||
| - | - |
| 0 | 1 |
AUX | RESET | |
c
| EJECT | |
SLOTSLOT | ||
| - | - |
| 0 | 1 |
AUX | RESET | |
|
| H10703 |
Both slots can be used at the same time. Use the following procedure to install a Flash memory card or Flash disk:
Step 1 Facing the GRP front panel, hold the Flash memory card or Flash disk with the connector end of the card toward the slot and the label facing right. (See Figure 14a.)
Note The Flash memory card or Flash disk is keyed and cannot be seated the wrong way. The ejector button will not pop out if the card is not properly inserted.
Step 2 Insert the card into the appropriate slot until the card completely seats in the connector at the back of the slot, and the ejector button pops out toward you. (See Figure 14b.)
Flash Disks and Flash Memory Cards in the GRP
36 |
| |
|
