Cisco Systems GRP-B manual Router# copy startup-config slot0myfile2

Implementing Additional Configuration and Maintenance Tasks

Step 2 Enter the copy startup-config slot0:filename command as follows:

Router# copy startup-config slot0:myfile2

20575008 bytes available on device slot0, proceed? [confirm] Address or name of remote host [1.1.1.1]?

Loading new.image from 1.1.1.1 (via Ethernet0):

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!![OK - 7799951/15599616 bytes]

CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC Router#

Note In the preceding example, the exclamation points (!!!) appear as the file is copied. The C characters signify calculation of the checksum—a verification that the file has been correctly copied.

You can also copy the running configuration (located in DRAM) to a Flash memory card or Flash disk, as shown in the “Copying Configuration File from GRP DRAM to Flash Memory Card or Flash Disk” section on page 45.

Step 3 Verify that the file was copied correctly using the dir command as follows:

Router# dir slot0:
-#-	-length-	-----date/time------	name
1	5200084	May 10 1997 19:24:12	gsr-p-mz.112-8

31215 May 10 1997 20:30:52 myfile1

46176844 May 10 1997 23:04:10 gsr-p-mz.112-8.1

51186 May 10 1997 16:56:50 myfile2

9197156 bytes available (11381148 bytes used) Router#

Copying Configuration File from GRP DRAM to Flash Memory Card or Flash Disk

Following is an example of copying your running configuration file from GRP DRAM to a Flash memory card or Flash disk in PCMCIA slot 0 or slot 1.

Note If using an ATA Flash disk, replace any commands that include a slot0: or slot1: command argument with a disk0: or disk1: command argument.

You can use the command copy running-config[slot0: slot1:]filename (Flash memory card), or

copy running-config [disk0: disk1:]filename (Flash disks) where running-config is the file’s source

(the temporary configuration in DRAM), and [slot0: slot1:]filename is the file’s destination in either of the Flash memory cards or Flash disks.

Flash Disks and Flash Memory Cards in the GRP

78-4339-09 45