For 6060L/V Corner Only
OPERATION
WARNING: Prior to operation, review the Important Safety Instructions listed at the beginning of this instruction manual.
Once the heater is installed and the whirlpool pump is operating, the heater is totally automatic. The heater will help maintain the temperature of the water in the bath.
Pressure Switch
The heater is equipped with a preset pressure switch. The pump must be running with water flowing in the whirlpool to allow the heater to turn on.
Indicator Light
This light turns on whenever the heater is operating.
High-Limit Switch
Fig. 1
| HEATER |
™ | |
| WHIRLPOOL |
HEATER “ON” LIGHT
FACTORY INSTALLED - NOT FOR RESALE
HEATER P/N: | Bonding Lug on |
| Heater Housing |
The heater includes an exclusive "Intelligent
To manually reset the circuit in the event that the
ELECTRICAL CONNECTIONS
Install a separate 120VAC / 15AMP dedicated circuit with GFCI (Ground Fault Circuit Interrupter) protection.
At initial
1.Route two separate branch circuits to the junction box near the whirlpool as shown in Figure 2. Each branch circuit MUST BE GFCI PROTECTED and must use copper conductors only.
2.Ensure the heater and pump are properly GROUNDED and BONDED as required. Attach the 8 AWG solid copper conductor supplied with the heater from the heater bonding lug to the motor frame bonding lug as shown in Figure 3. The conductor is secured to the lugs using set screws. The motor frame shall have a second 8 AWG solid copper conductor connected from the frame bonding lug to the homes electrical panel or approved local bonding point as shown in Figure 3.
Fig. 2 |
|
|
| SEPARATE |
| Fig. 3 |
| ||||
| 15 AMP GFCI OUTLET | ELECTRICAL INSTALLATION |
| ||||||||
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
| ||||
120 VAC |
|
|
|
|
| (HEATER) |
| ||||
|
|
|
|
|
|
|
|
| |||
WHITE | BLACK |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| HEATER ON |
HEATER | |
™ | WHIRLPOOL |
|
|
| (PUMP/MOTOR) |
| GND. |
|
|
|
| HEATER | RUN 8 AWG SOLID COPPER |
|
|
| |
|
|
| CONDUCTORS FROM |
|
|
| HEATER BONDING LUG TO |
| SEPARATE 15 AMP GFCI OUTLET |
| PUMP/MOTOR FRAME LUG |
|
| AND FROM PUMP/MOTOR | |
|
|
| |
| SEPARATE 20 AMP GFCI OUTLET |
| LUG TO APPROVED |
| (for 2.1 H.P.R. PUMP ONLY) |
| GROUND AS SHOWN |
120 VAC |
|
| |
|
|
| FIRST COPPER |
WHITE | BLACK |
| CONDUCTOR |
| SECOND | ||
|
|
| COPPER |
|
|
| CONDUCTOR |
|
|
| PUMP/MOTOR FRAME WITH |
|
|
| BONDING LUGS |
TO GROUND
PUMP/MOTOR
GND.
ELECTRICAL DIAGRAM
READ AND FOLLOW ALL INSTRUCTIONS
13 |