American Standard 3572, 3574, 3575 manual Air Massage System Electrical Installation Instructions

AIR MASSAGE SYSTEM

ELECTRICAL INSTALLATION INSTRUCTIONS

All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes.

!WARNING: When using electrical products, basic precautions should always be observed, including the following:

1.DANGER: RISK OF ELECTRIC SHOCK! Connect only to a circuit protected by a ground-fault circuit interrupter.

2.Permit access for servicing blower as noted.

3.All building materials and wiring should be routed away from the air blower.

AIR MASSAGE SYSTEM:

The air bath should be installed on a 10 vac, 15 or 0 amp dedicated circuit. The circuit should be hard-wired from the electrical power supply panel. The circuit must be a three (3) wire circuit from the electrical supply panel. A grounded neutral wire and a third wire, earth ground, are essential.

USE 15 OR 20 AMP

GFCI OUTLET

120 VAC

WHITE BLACK

GND. AIR BLOWER

ELECTRICAL DIAGRAM

READ AND FOLLOW ALL INSTRUCTIONS CHROMATHERAPY LIGHT

CONTROL BOX (OPTIONAL)

WIRE SELECTION GUIDE
		Maximum distance from
			fusebox to motor
Motor
	50'		100'	150'	200'
Hi Performance
Rating			115V Power Line
2.1 H.P.,
1.4 H.P.,	12		10	8	8
and 1.25 H.P.

The sizes shown on this

chart are recommendations

for copper conductors only. Always follow local and national electrical codes

754063-100 Rev. B