DRAIN CONNECTION continued...
18.Tighten chrome overflow retainer onto drain overflow assembly pipe per photo Q below.
19.Align flat on drain actuator shaft with corresponding flat in chrome metal overflow escutcheon and tighten set screw to fix overflow escutcheon in place per photos R and S.
Q.
R.
S.
20.Rotate left and right lightly to feel stops in drain cable control. This opens and closes drain.
21.Place drain stopper into drain waste hole as shown in photo T.
T.
22.The drain stopper should prevent water from draining out of tub when the escutcheon is in the fully counterclockwise position as shown in photo U. Adjust the drainstopper bolt to obtain the best water seal in the tub.
U.
23.Rotate Drain Escutcheon to clockwise stop. This should open drain, between 1/" and 1/4", to allow water to exit bath. If not adjust metal bolt in drain stopper to allow draining function, but not so high that drain will not seal when closed to hold water during use. See photo V.
V.
13 |
