American Standard 3808.101 10TEST INSTALLED FITTING, Check Drain Connections, 11SERVICE

10 TEST INSTALLED FITTING

With HANDLE (1) in OFF position, turn on WATER SUPPLIES (2) and check all connections for leaks.

Remove AERATOR (3).

Operate HANDLE (1) to flush water lines thoroughly.

Replace AERATOR (3).

CHECK DRAIN CONNECTIONS

Operate POP-UP KNOB (4) and fill lavatory with water. Check that DRAIN STOPPER (5) makes a good seal and retains water in SINK. If DRAIN STOPPER (5) does not seal properly, please refer to Troubleshooting section in these instructions.

Release POP-UP KNOB (4) down and check all drain connections and "P" trap for leaks. Tighten

if necessary.

4

1

3

5

WASTE

OUTLET

2

2 “P” TRAP

11 SERVICE

IF FAUCET DRIPS

If faucet drips, operate handle several times from "off" to "on". Do not apply excessive force.

Clogged CARTRIDGE (5) inlets may cause reduced flow in "full on" hot or cold. To clean inlets, first turn off water supply, then:

Remove HANDLE (1), CAP (2) CARTRIDGE SCREWS (3) RETAINER (4) and CARTRIDGE (5).

Clean inlets on CARTRIDGE (5).

Reassemble CARTRIDGE (5), RETAINER (4) alternately tightening SCREWS (3), CAP (2) and HANDLE (1). Check flow.

3

4

1

5

2

HOT LIMIT SAFETY STOP

By restricting handle rotation and limiting the amount of hot water allowed to mix with the cold, the HOT LIMIT SAFETY STOP reduces risk of accidental scalding. To set the maximum hot water temperature of your faucets, all you need

to do is adjust the setting on the HOT LIMIT SAFETY STOP.

Remove necessary trim parts. Use a flat blade screwdriver or pull forward with your fingers to rotate red HOT LIMIT SAFETY STOP. Follow Step "A" or "B" to adjust max./min. discharge temperature. "0" being the hottest to "7" the coldest temperature setting.

"A"

	ADJUSTMENT WHEN
POINTER ON	WATER IS TOO HOT	"A"
		PRY RED RING FORWARD
HOT LIMIT STOP
		AND ROTATE COUNTER-
"B"	0	CLOCKWISE ONE CLICK
	1
ADJUSTMENT WHEN
	2
WATER IS TOO COLD	3
	4
"B"	5
PRY RED RING FORWARD
AND ROTATE CLOCKWISE
		RED RING HOT
		LIMIT SAFETY
		STOP

12 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

51314 Rev . 1 . 3

4