American Standard 4508.801 Install Handles, Test Installed Fitting, Check Drain Connections

10 INSTALL HANDLES
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without a spline is facing up. See figure "A". Tighten		THREAD ON
STEM SCREW (3) to secure ADAPTER (1).
		TO DECK
Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting	4	ADAPTER
male teeth on ADAPTER (1) to female teeth in HANDLE (4).	TOP
Thread LEVER HANDLE ASSEMBLY (4) onto DECK ADAPTER (5)		1
until snug against mounting surface.
		3
Figure "A"
		2
SPLINE END DOWN		5

11		TEST INSTALLED FITTING
			5
	With HANDLES (1) in OFF position, turn on WATER			1

SUPPLIES (2) and check all connections for leaks.

Remove AERATOR (3).

Operate both HANDLES (1) to flush water lines thoroughly.

Replace AERATOR (3). 1

12 CHECK DRAIN CONNECTIONS

3

Operate POP-UP KNOB (5) and fill Sink with water. Check that DRAIN STOPPER (4) makes a good seal and retains water in Sink. If STOPPER (4) does not seal properly, please refer to “Troubleshooting Guide” in these instructions.

Release POP-UP KNOB (5) down and check all drain connections and "P" trap for leaks. Tighten

if necessary.

4

WASTE

OUTLET

2

COLD

“P” TRAP

2

HOT

13 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER.DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

14 SERVICE			HANDLE
To change direction of handle rotation,			ASSEMBLY
proceed as follows:
Turn valve to OFF position. Unthread HANDLE	UNTHREAD
BASE (1) from DECK ADAPTER (2).
Pull HANDLE ASSEMBLY off VALVE STEM (3).		1
Remove SPRING CLIP (4). Lift STOP WASHER (5),
turn 90˚ and replace. Replace SPRING CLIP (4).
Find correct position of HANDLE ASSEMBLY by adjusting		90˚	3
male teeth on VALVE STEM (3) to female teeth in HANDLE.			5
Thread HANDLE ASSEMBLY onto DECK ADAPTER (2)
until snug against mounting surface.		4
If spout drips, operate handles several times from	2
OFF to ON position. Do not force - handles turn

only 90˚ .

M968832 Rev . 1 . 3

4