10 INSTALL HANDLES |
|
|
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the |
|
|
ADAPTER (1) without a spline is facing up. See Figure "A". Tighten |
| THREAD ON |
STEM SCREW (3) to secure ADAPTER (1). |
| |
| TO DECK | |
Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting | 4 | ADAPTER |
|
| |
male teeth on ADAPTER (1) to female teeth in HANDLE (4). | TOP |
|
|
| |
Thread LEVER HANDLE ASSEMBLY (4) onto DECK ADAPTER (5) |
| 1 |
until snug against mounting surface. |
| |
| 3 | |
Figure "A" |
| |
|
| 2 |
SPLINE END DOWN |
| 5 |
11 TEST INSTALLED FITTING |
| 5 |
|
| |
With HANDLES (1) in OFF position, turn on WATER | 1 | |
SUPPLIES (2) and check all connections for leaks. |
| |
Remove AERATOR (3). |
|
|
Operate both HANDLES (1) to flush water |
|
|
lines thoroughly. | 1 | 3 |
| ||
Replace AERATOR (3). |
|
|
12 CHECK DRAIN CONNECTIONS
Operate 
that DRAIN STOPPER (4) makes a good seal and retains 
water in Sink. If STOPPER (4) does not seal properly, please 
refer to “Troubleshooting Guide” in these instructions. 
Release
connections and "P" trap for leaks. | Tighten |
if necessary. | WASTE |
| OUTLET |
4
2
COLD
HOT
“P” TRAP
2
13 CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER.DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.
14 SERVICE |
|
To change direction of handle rotation, |
|
proceed as follows: |
|
Turn valve to OFF position. Unthread HANDLE | UNTHREAD |
BASE (1) from DECK ADAPTER (2). |
|
Pull HANDLE ASSEMBLY off VALVE STEM (3). | 1 |
Remove SPRING CLIP (4). Lift STOP WASHER (5), |
|
turn 90˚ and replace. Replace SPRING CLIP (4).
Find correct position of HANDLE ASSEMBLY by adjusting | 90˚ | |
male teeth on VALVE STEM (3) to female teeth in HANDLE. | ||
Thread HANDLE ASSEMBLY onto DECK ADAPTER (2) |
|
|
until snug against mounting surface. | 4 |
|
HANDLE
ASSEMBLY
3
5
If spout drips, operate handles several times from | 2 |
OFF to ON position. Do not force - handles turn |
|
only 90˚ .
M968479 Rev . 1 . 2
4
