AT&T Release 2.0 manual DSS Installation Procedure

Installing Telephones and Adjuncts

DSS Installation Procedure

NOTE:

If you are connecting two DSSs to the telephone, unpack the second DSS now.

1.Adjust the angle of the DSS. For instructions on removing the telephone stand, see Figure 3-2earlier in this chapter.

The DSS is packed fully assembled with the desk stand in the low position. If you-prefer the low position, go to Step 2. To adjust the angle of the DSS to the high position, place the DSS face down on a flat surface and follow these steps:

a.Press on the top rear center of the stand to release the tab. Pull the stand toward you and away from the DSS.

b.To adjust the stand to the high position, insert the tab at the bottom of the stand into the other slot.

c.Lower the stand and press the tab at the top into the corresponding slot on the DSS.

2.Install the D8AC cord on the DSS. See Figure 3-14.

a.There are two jacks on the DSS labeled IN and OUT. Plug one end of the D8AC cord into the jack labeled IN.

b.Route the D8AC cord through the cord channel on the left side of the DSS.

■If you are installing one DSS, go to Step 4.

■If you are installing two DSSs, repeat Steps 1 and 2 for the second DSS; then go to Step 3.

3.Wire the two DSSs. See Figure 3-14.

a.Place the two DSSs side by side and face down.

3-32Installing the Direct Station Selector