AT&T Release 2.0 manual Connecting a Printer Within 50 Feet

Installing the PC, CAT, or Printer

Connecting a Printer (Within 50 Feet)

If the printer is within 50 ft (15 m) of the control unit and is connected to the same 117-VAC branch as the control unit, use the hardware and procedures in this section.

Hardware

■Z200A EMI filter

■adapter for the connector on the interface cable

—355A for a male connector

—355AF for a female connector

Procedure: Connecting the Printer (Within 50 Feet)

1.Plug the short end of the Z200A EMI cord into the SMDR jack on the control unit (the upper jack).

See Figure 5-3for the entire procedure.

2.Plug the other end of the Z200A EMI cord into the adapter (355AF or 355A).

3.Connect the female connector on the adapter to the 25-pin male connector on the printer’s interface cable, or into the parallel or serial port (depending on the printer type) on the printer.

4.Set the printer options for use with the SMDR feature. See the section, “Setting Printer Options,” for the appropriate printer setting for the printer.

5-14Connecting a Printer to the Control Unit