AT&T Release 2.0 manual Installing a Ring Generator in the Power Supply

Installing the Control Unit

P 2

P 1

WIRE

C L I P

RING GENERATOR

P202

P101

WIRE MANAGER:

MAKE SURE THE MODIFICATION LABEL IS ATTACHED WHEN FINISHED: "EQUIPPED WITH 129B FREQ GEN"

Figure 2-9. Installing a Ring Generator in the Power Supply

e.Carefully turn the module over on its right side and then remove the top of the power supply housing.

f . Position the ring generator as shown in Figure 2-9 and align the screw holes.

Installing the Power Supply 2-31