Installing Telephones and Adjuncts

NOTE:

To install or replace an MFM in a previously wall-mounted MLX-10 or MLX-10D telephone, go to Step 2c.

a.Place the telephone face down on a flat surface. Press on the top rear center of the stand to release the tab.

b.Pull the stand toward you and away from the telephone.

c.Use a screwdriver to remove the screw in the lower right-hand corner of the module cover.

d.Press the center of the right side of the module cover with one hand and lift the cover to remove it.

3.To remove an existing MFM, do the following (see Figure 3-3):

Disconnect any cords attached to the phone, taking precautions to make sure you will reconnect them to the appropriate jacks.

If the telephone does not have an existing MFM, go to Step 4.

To reset the jumpers on an existing MFM, go to Step 5.

a.Locate the MFM locking tabs on the top and bottom of the telephone. Spread these tabs apart to release the MFM.

b.Grasp the MFM by the edges and pull it toward you to free the connector pins. Do not touch the connector pins. Set the MFM aside on a clean surface.

3-6Installing the Multi-Function Module

Page 109
Image 109
AT&T Release 2.0 manual