Initializing and Testing the System

Testing Incoming Automatic-Start Tie Trunks

Perform this test for automatic-start tie trunks that are two-way or incoming only. If you are testing two-way automatic-start tie trunks, perform the outgoing test as well.

1. At the far-end tie-trunk site, have someone pick. up the handset and access a tie trunk assigned to a button on your telephone.

Your telephone should ring, and the LEDs next to the tie-trunk button should respond as follows:

red LED should turn on

green LED should flash

2.Pick up your handset and verify that you have good two-way communication.

The green LED should change from flashing to on.

3.At your telephone and the distant telephone, hang up.

The green LED should turn off, the red LED will turn off, and another red LED may turn on.

4.Repeat Steps 1 through 3 for all incoming and two-way automatic-start tie trunks.

7-18Testing the System

Page 295
Image 295
AT&T Release 2.0 manual Testing Incoming Automatic-Start Tie Trunks