Installing. the Control Unit

Step 2b: Replacing the Feature Module

It may become necessary at some point to replace the feature module because of upgrades or malfunctions.

CAUTION:

Make sure that you have a backup of the system programming before replacing the feature module. (When the feature module is replaced, system programming is lost.) See Chapter 7 for information on the backup procedure.

Follow this procedure to replace the feature module in a fully installed system:

a.Turn off the system (see “Powering Down the System” later in this chapter). Make sure the switch on the power supply is turned off.

b.Remove the processor from the carrier:

i.Press upon the tab on the bottom-rear of the module.

ii.Pull the bottom of the module away from the carrier.

iii.Lift upward to disengage the module from the rod on the top of the carrier.

c.Put the processor on a flat surface.

d.Grasp both metal rings on the outside of the feature module and pull straight up.

CAUTION:

Grasping onfy one of the rings may cause damage to components on the processor circuit board or feature module.

Installing the Processor

2-45

Page 84
Image 84
AT&T Release 2.0 manual Replacing the Feature Module