AT&T Release 2.0 manual Tools and Equipment, Using the System Forms

Introduction to Installation

Tools and Equipment

A list of required tools and equipment is provided just before each procedure throughout this guide.

System Forms

Throughout this guide, the installation procedures refer to system forms. These forms indicate information that is specific to your customer’s system. The forms that you need should be included with the system programming diskette, which contains all of the programming specifically for your customer’s system.

If you find that you do not have a fully completed set of planning forms for your customer’s system, contact your technical support organization or the Customer Service Center (CSC). See the inside of the front cover for telephone numbers.

Using the System Forms

Not all of the system forms are necessary for each system.

The following sections list the forms according to the following categories:

■Installing the control unit

■Installing telephones and adjuncts

■Connecting the network interface

■Connecting data equipment

■Programming the system

System Forms 1-3