AT&T Release 2.0 manual Installing the Feature Module

Installing the Control Unit

Step 2a: Installing the Feature Module

This procedure is part of a larger procedure for installing the processor. If you have not already read the beginning of this section, “Installing the Processor,” do so before continuing.

Upgrades: If you are upgrading an existing system, skip to

“Step 2b: Replacing the Feature Module.”

Before you install the processor in the carrier, you must install the feature module in the processor:

a.Unpack the feature module.

b.Fasten the round feature module label to the front of the processor housing.

c.Put the processor on a flat surface as shown in Figure 2-13.

d.Align the connectors on the feature module with the connectors in the processor as shown in Figure 2-13.

e.When you are sure that the feature module is properly seated, press it firmly into place.

Installing the Processor 2-43