AT&T Release 2.0 manual Modifying the Processor for Key Mode

Installing the Control Unit

Step 1: Modifying the Processor for Key Mode

CAUTION:

■This procedure is part of a larger procedure for installing the processor. If you have not already read the beginning of this section, “Installing the Processor,” do so before continuing.

■This procedure must be performed for KF registration with the FCC.

■This procedure prevents the system from being programmed as a Hybrid/PBX system. Do this only if the system is programmed for Key mode and GS trunks are not indicated on Form 2c, System Numbering—Trunk Jacks.

Otherwise, skip to the next section, “Step 2a: Installing the Feature Module.”

a.Remove the processor from its package.

b.Put the processor on a flat surface.

c.If the feature module is installed, remove it as indicated later, under “Step 2b: Replacing the Feature Module.”

CAUTION:

Do not touch the HDR3 header on the processor board, which is exposed when the feature module is not instal!ed in the processor. If the HDR3 header is removed, the system programming may be deleted and have to be restored.

See Figure 2-12.

Installing the Processor 2-41