Installing Telephones and Adjuncts

c.Lower the cover to the right and press firmly to lock the tabs in place. Both tabs must be secure.

d.Replace and tighten the screw you removed earlier.

7.Replace the desk stand and the user card tray.

NOTE:

If you are wall mounting an MLX-10 or MLX-10D telephone, do not replace the desk stand. Go to Step 8.

a.The desk stand has two height adjustments. Insert the tab at the bottom of the stand in either the low or high position.

b.Insert the tab at the top of the stand into the corresponding slot on the desk telephone. To readjust the stand, see the instructions on the bottom of the card tray.

8.Power up the telephone as follows (see Figure 3-6):

a.Plug the D8W cord from the telephone into the 8-conductor (large) modular jack of the 400B or 400B2 adapter.

b.Connect one end of the D6AP cord to the 2-conductor (small) modular jack on the 400B or 400B2 adapter, and plug the other end into the modular jack of the KS22911-L2 power supply. The total length of the cords connecting the power supply to the MLX telephone must be less than or equal to 50 ft (15 m).

CAUTION:

Do not plug the D6AP cord into the 8 conductor (large) modular jack on the 400B or 400B2 adapter; doing so can cause electrical damage to the control unit and the telephone.

3-10Installing the Multi-Function Module

Page 113
Image 113
AT&T Release 2.0 manual 10Installing the Multi-Function Module