Installing Telephones and Adjuncts

8.As shown on the template, mount the wire troughs on column 2 after all the field-terminated blocks have been wired.

9.Mount the D-rings between the columns as needed to route the patch cords.

10.Plug one end of a D8W cord into the proper control unit module telephone jack and the other end into the corresponding jack on the termination block in column 1 or column 3.

11.Repeat for all the D8W cords.

12.Route the D8W cords through the wire trough above the termination block. See Figure 3-26and Figure 3-27.

NOTE:

Each kit has extra D-rings and wire troughs. Use them as needed to route the cords.

13.Label the termination and field-terminated blocks. See “Label the System Wiring” later in this chapter). Write the appropriate information (such as extension numbers and users’ names) on the strip labels provided and snap the designation strips into place.

14.Use the 110P8A5B patch cords to connect termination blocks to field-terminated blocks. See Figure 3-33.Properly route the patch cords through the wire troughs and D-rings.

3-62Connecting the Telephones to the Control Unit

Page 165
Image 165
AT&T Release 2.0 manual