AT&T Release 2.0 manual Testing the Tie Trunks, Testing Two-Way Automatic-Start Tie Trunks

Initializing and Testing the System

Testing the Tie Trunks

Before making the following tie-trunk tests, make sure that the tie trunks for the system are connected and properly programmed, and have someone at the far end ready to place and receive calls throughout these testing procedures.

The tie trunk testing procedures in this section are as follows:

■automatic-start two-way (both incoming and outgoing)

■automatic-start incoming only

■automatic-start outgoing only

■dial-repeating two-way (both incoming and outgoing)

■dial-repeating incoming only

■dial-repeating outgoing only

Testing Two-Way Automatic-Start Tie Trunks

For two-way automatic-start tie trunks, perform both of the automatic-start tie trunk tests (incoming and outgoing).

NOTE:

Before testing outgoing or two-way automatic-start tie trunks, have someone ready to receive your call at the receiving telephone.

Testing the System 7-17