AT&T Release 2.0 manual Testing Incoming Dial-Repeating Tie Trunks

Initializing and Testing the System

Testing Incoming Dial-Repeating Tie Trunks

Perform this test for dial-repeating tie trunks that are two-way or incoming only. If you are testing two-way dial-repeating tie trunks, perform the outgoing test as well.

1 . Have the person at the far end place a dial-repeating call to your telephone by dialing the proper tie-trunk number.

Your telephone rings, and the green LED next to ICOM (or SA for Hybrid/PBX systems) flashes.

2 . Pick up the handset.

The red LED next to the ringing button turns on, and the green LED changes from flashing to on.

3 . Verify that you have good two-way communication and hang up.

The green LED should turn off, the red LED will turn off, and another red LED may turn on.

4 . Repeat Steps 1 through 3 for each incoming or two-way dial-repeating tie trunk.

Testing Outgoing Dial-Repeating Tie Trunks

Perform this test for dial-repeating tie trunks that are two-way or outgoing only. If you are testing dial-repeating two-way tie trunks, perform the incoming test as well.

1.At any telephone that has access to a dial-repeating tie trunk, press the first tie-trunk button.

The red LED next to the pressed tie-trunk button turns on.

2.Pick up the handset.

The green LED next to the selected button turns on.

7-20Testing the System