Installing the Control Unit

b.Label each telephone jack sequentially, 1 through 144. Begin with the module in slot 1, numbering from bottom to top on each module and working from left to right across the carrier.

CAUTION:

The 008 OPT module is assigned 12 Logical IDs, and the last four numbers are not assigned to jacks. For example, if the previous module (on the left) is labeled with Logical IDs 1 through 8, label the 008 OPT jacks with Logical IDs 9 through 16. Skip numbers

17 through 20.

When you label the next module (on the right), label the first jack as Logical ID 21.

Removing a Module

Follow this procedure to remove a module:

1.Follow the procedure in the last section of this chapter, “Powering Down the System.”

2.Push up firmly on the tab at the bottom rear of the module.

3.While holding up the tab, swing the bottom of the module toward you, away from the carrier.

4.Lift up the module to disengage it from the rod on the top of the carrier.

Installing the Modules 2-59

Page 98
Image 98
AT&T Release 2.0 manual Removing a Module