AT&T Release 2.0 manual Using the D-Impact Tool to Seat the Conductors

Installing Telephones and Adjuncts

Figure 3-25. Using the D-Impact Tool to Seat the Conductors

iv.Remove any insulation fragments with a spudger (see Figure 3-23if you do not know which tool is the spudger).

d.Repeat Steps a through c above for each termination block.

5.Mount the wire troughs.

6.As needed, mount the D-rings.

7.Label the D8W cords, termination blocks, and DIW cables properly. See “Label the System Wiring” later in this chapter.

8.Plug one end of a D38W cord into the telephone jack on the control unit module and the other end into the designated jack on the termination block. Do this for all telephones.

Connecting the Telephones to the Control Unit 3-51