Installing Telephones and Adjuncts

MLX telephones are packed fully assembled with the desk stand in the low position. The angle of any MLX desk telephone can be adjusted to the high position. If you are wall mounting an MLX-10 or MLX-10D telephone, you must first remove the desk stand. To remove the desk stand or adjust its angle, place the telephone face down on a flat surface and follow these steps:

a.Press on the top rear center of the stand to release the tab(s). Pull the stand toward you and away from the telephone.

b.To adjust the stand to the high position, insert the tab(s) at the bottom of the stand into the slot(s).

c.Lower the stand and press the tab(s) at the top into the corresponding slot(s) on the telephone.

NOTE:

The diagram on the bottom of the user card tray also shows the steps to adjust the stand.

2.Connect the line cords. See Figure 3-7earlier in this chapter.

a.Plug one end of the D8W cord into the telephone jack labeled LINE on the underside of the telephone.

b.Route the D8W cord through the cord channel on the back of the telephone.

c.If the telephone is for desktop use, turn the desk telephone face up and plug the D8W cord into the wall jack.

3.Install the handset by inserting one end of the coiled H4DU handset cord into the handset and the other end into the jack on the side of the telephone.

Assembling the MLX Telephone 3-37

Page 140
Image 140
AT&T Release 2.0 manual