AT&T Release 2.0 manual Testing Selected System Features

Initializing and Testing the System

NOTE:

In Hybrid/PBX systems with pooled tie trunks, press SA and dial the pool dial-out code.

3 . Dial the tie-trunk number of the station where someone is waiting for your call. You hear ringing.

4 . When the person answers, verify that you have good two-way communication and hang up.

The green LED should turn off, the red LED will turn off, and another red LED may turn on.

5 . Repeat Steps 1 through 4 for each outgoing or two-way dial-repeating tie trunk.

Testing Selected System Features

The procedures in this section, listed below, test selected system features:

■Automatic Route Selection (ARS), which is for Hybrid/PBX mode only.

Use the same test for Idle Line Preference code, which is a similar feature that is used in Key mode only.

Use the same test for Station Message Detail Recording (SMDR) as explained in the test procedure.

■Group Calling

Use the same test for the Listed Directory Number (the QCC queue), which is for Hybrid/PBX only.

Use the same test for Group Page.

■System Speed Dial

■Coverage

If any feature is not working properly, check the system programming. You can run these tests most easily from an MLX telephone or an analog multiline telephone.

Testing the System 7-21