AT&T Release 2.0 manual Connecting a PC Within 50 Feet, Procedure Connecting the PC Within 50 Feet

Installing the PC, CAT, or Printer

CAUTION:

To prevent damage from electrostatic discharge (ESD), avoid touching leads, connectors, pins, and other components. Use a properly grounded wrist strap.

Connecting a PC (Within 50 Feet)

Use the hardware and procedures in this section to connect a PC to the control unit when the distance is less than 50 ft (15 m). See Figure 5-1.

Hardware

■355AF adapter

■D8W cord

■EIA-232-D cable (optional; use only if preferred)

Procedure: Connecting the PC (Within 50 Feet)

1.For system programming or system maintenance, plug one end of a D8W cord into the SPM jack on the control unit (the lower jack).

NOTE:

For SMDR, plug the D8W cord into the SMDR jack (the upper jack) instead of the SPM jack.

2.Plug the other end of the D8W cord into a 355AF adapter.

3.If you are using the EIA-232-D cable, connect one end to the 355AF adapter and the other end to the COM1 port on the PC.

If you are not using the EIA-232-D cable, connect the 355AF adapter directly to the COM1 port on the PC.

5-2Connecting a PC to the Control Unit