AT&T Release 2.0 manual Connecting Data Equipment, Programming the System

Introduction to Installation

■Form 2c, System Numbering—Trunk Jacks

■Form 3a, Incoming Trunks—Remote Access

■ Form 3b, Incoming Trunks—DS1 Connectivity (100D Module)

■Form 3d, Incoming Trunks—DID

Connecting Data Equipment

The following forms indicate the data equipment needed to setup data stations and modem pools, as described in Chapter 6:

■Data Form 1a, Modem Pool—Analog to Digital

■Data Form 1b, Modem Pool—Digital to Analog

■Data Form 2a, Analog Data Station

■Data Form 2b, Digital Data Station

■Data Form 3, Data Hunt Groups

Programming the System

If you have a system programming diskette that was created using SPM, you do not need to program the system. Use that diskette to restore the system as described in Chapter 7. If you did not receive this diskette and it is your responsibility to program the system, see the System Programming guide for instructions. Each programming procedure indicates the appropriate form.

System Forms 1-5