Installing Telephones and Adjuncts

— When connecting the adjunct to a single-line telephone, do the following:

a. Connect a 267A2 bridging adapter to the telephone.

b. Connect the cord from the adjunct to the bridging adapter.

c. Reconnect the cord from the control unit to the bridging adapter.

— When connecting the adjunct to an analog multiline telephone, do the following:

a. Connect a 4-pair cord to the OTHER jack on the telephone.

b. Connect the other end to the VT jack on a general purpose adapter (GPA).

c. Connect the cord from the adjunct to the TEL/EQUIP

. -

jack on the GPA.

NOTE:

See the next section, “General Purpose Adapter (GPA),” for additional information.

When connecting the adjunct to the 012 module, connect the adjunct cord directly to the logical ID indicated on the system form.

3.When connecting adjuncts to telephones, make sure you route the adjunct and D8W telephone cords through the cord channel.

See Figure 3-7.

4.Test the adjunct by dialing its associated extension.

Installing Adjuncts 3-13

Page 116
Image 116
AT&T Release 2.0 manual