Installing Telephones and Adjuncts

Supplemental Alerts

Alerting devices notify people working in noisy areas of incoming, transferred, and inside calls.

Connect a supplemental alert device to one of the following, as described earlier in this section:

single-line telephone

MLX telephone with an MFM

supplemental alert adapter (SAA) and analog multiline telephone

NOTE:

See the next section, “Supplemental Alert Adapter (SAA),” for installation instructions.

The MFM and SAA support devices operating on 48 VDC, Alerts operating on 20-30 Hz can be connected to an MFM or a single-line telephone jack.

Supplemental Alert Adapter (SAA)

When the system forms indicate the installation of a bell, horn, chime, or strobe with an analog multiline telephone, install the SAA as follows (see Figure 3-13).

1.Plug the telephone cord into the jack labeled TELEPHONE on the SAA.

2.Plug the cord from the alert device into the jack labeled ALERTER on the SAA.

3.Plug the cord from the telephone jack into the jack labeled CONTROL UNIT on the SAA.

Installing Adjuncts 3-27

Page 130
Image 130
AT&T Release 2.0 manual Supplemental Alerts, Supplemental Alert Adapter SAA