Installing the PC, CAT, or Printer

9.Plug the other end of the D6AP cord into the 2012D-50M transformer.

NOTE:

If you are working with a 248B adapter and 2012D transformer instead of a 2012D-50M transformer, plug the D6AP cord into the jack on the 248B adapter, and then connect the spade-tip wires on the 248B adapter to the screws on a 20120 transformer

(see Figure 5-5).

10.Plug the 400B2 adapter into a wall jack, BR1A-4P adapter, 102 connecting block, or 103 connecting block.

11.If the 400B2 is plugged into a wall jack, make sure that building wiring has been set up so that the control unit-side wall jack communicates with the printer-side wall jack.

If the 400B2 is plugged into a BR1A-4P adapter, 102 connecting block, or 103 connecting block, use 4-pair plug-ended cable to connect the BR1A-4P adapter (or connecting block) to the printer-side wall jack.

12.On the printer side, plug one end of a D8W cord into the wall jack and the other end into the WALL jack on the Z3A2 ADU.

13.Connect one end of an EIA-232-D cable to the 25-pin male connector on the Z3A2 ADU and the other end to the parallel or serial port (depending on the printer type) of the printer.

14.Plug the 2012D-50M (or 2012D) transformer into a wall outlet.

15.Set the printer options for use with the SMDR feature. See the section, “Setting Printer Options,” for the appropriate printer setting for the

printer.

Connecting a Printer to the Control Unit

5-19

Page 238
Image 238
AT&T Release 2.0 manual