Installing Telephones and Adjuncts

Hardware

Each kit includes the following:

instructions and parts sheet

110AB1-100JP12 termination blocks with modular jacks

110A1 wire troughs

D-rings

D8W cords

Tools

D-impact tool

spudger

hand tools

See Figure 3-23.

Telephone Installation Procedure (More than 24)

1.Drill two diagonally opposite holes in a suitable backboard (plywood is recommended) for each piece of hardware. Keep a 1/16-inch (1.6-

mm)space between each piece of hardware.

2.Mount the wire troughs and the termination blocks. There is a wire trough above each termination block.

3.If necessary, repeat Steps 1 and 2 for a second column.

4.Mount the termination blocks and terminate the telephone cable. If the telephone cable is bottom feed, start at the top and work down. If the telephone cable is top feed, start at the bottom and work up.

a.Mount a termination block to the wall with appropriate fasteners.

b.Strip the jacket off the DIW telephone wires, exposing the conductors.

Connecting the Telephones to the Control Unit 3-49

Page 152
Image 152
AT&T Release 2.0 manual Hardware, Telephone Installation Procedure More than