AT&T Release 2.0 manual Merlin Attendant, IS-III Documentation

Installing Applications

Installation Procedure

For detailed installation instructions, see the “IS-III Documentation” section later in this chapter for the appropriate document title.

Highlights of these instructions are as follows:

1.Set up the equipment and identify the hardware for IS-III.

2.Connect the hardware as shown in the instructions.

3.Install the software. Test the IS-III application.

If a voice application is installed you will need two 125-Mbyte tape cartridges for system backup.

IS-III Documentation

Integrated Solution III Installation and Maintenance Guide

MERLIN Attendant

The MERLIN Attendant is a stand-alone application that provides operator-like services through the use of prerecorded messages and electronic switching.

Considerations

■The MERLIN Attendant cannot be connected to a system that operates in the Behind Switch mode.

■The MERLIN Attendant cannot be connected to a system that has an AUDIX application or a Voice Mail system installed.

■A maximum of four Attendants can be connected to the system.

■All lines to MERLIN Attendant should be programmed for reliable far- end disconnect.

MERLIN Attendant 8-21