AT&T Release 2.0 manual Using the D-Impact Tool to Seat the Conductors

Connecting the Control Unit to the Network Interface

Figure 4-4. Using the D-Impact Tool to Seat the Conductors

9.Label the network interface jacks, control unit module jacks, termination blocks, and D2R cords (see “Labeling Trunks” later in this chapter).

10.For each trunk, plug one end of a D2R cord into the designated jack on the termination block and the other end into the trunk jack on the proper control unit module.

NOTE:

The modular jacks on the termination block are 8-wire jacks. The D2R cords, which are 6-wire, will plug into the 8-wire jacks as well.

4-10Wiring