AT&T Release 2.0 manual Hardware Requirements

Installing Applications

Hardware Requirements

The Master Controller II+ (Desktop) and the Master Controller III (Tower) are the PC platforms for IS III.

The Master Controller II+ is a desktop 20 Mhz, 386-SX PC with three available AT bus slots (with the tape drive installed). It has 8 Mbyte of RAM memory, either 100 Mbyte or 200 MB hard disk drive, 3.5 inch floppy drive, and

125 Mbyte streaming tape drive.

The Master Controller III is a tower 20 Mhz 486-SX PC with six available EISA bus slots (with the tape drive installed). It has 8 Mbyte of RAM memory, either 200 or 500 Mbyte hard disk drive, and 250 Mbyte streaming tape drive.

■A 355AF adapter for connecting the Master Controller to the serial port on the control unit if they are within 50 ft (15 m) of each other and are on the same AC branch circuit

■ADUs for connecting the Master Controller to the serial port on the control unit, if they are not within 50 ft (15 m) of each other and/or are not on the same AC branch circuit

■Any additional hardware required by the individual applications included in IS-III, including the cables and adapters for connecting the applications to the system

■IVP4 boards or IVP6 cards for AUDIX Voice Power and FAX Attendant

■012 basic telephone module to provide the tip/ring interface for AUDIX Voice Power

■TR114 boards for FAX Attendant

8-20Integrated Solution III