AT&T Release 2.0 manual Installing the Control Unit, Installing Telephones and Adjuncts

Introduction to Installation

Installing the Control Unit

■Form 1, System Planning (the Control Unit Diagram on the back)

■Form 3c, Incoming Trunks—Tie

Some of the procedures in Chapter 2 refer to the Control Unit Diagram, which is the second side of Form 1, System Planning.

If you are installing a 400EM module in the control unit, you need Form 3c, Incoming Trunks—Tie to determine the switch settings prior to installing the module in the control unit.

Installing Telephones and Adjuncts

The following forms indicate the telephones and adjuncts that are to be installed, as described in Chapter 3.

■Form 2a, System Numbering—Station Jacks

■Form 2b, System Numbering—Digital Adjuncts

■Form 4b, Analog Multiline Telephone

■Form 4d, MLX Telephone

■Form 4e, MFM Adjunct—MLX Telephone

■Form 4f, Tip/Ring Equipment

■Form 5a, Direct-Line Console (DLC)—Analog

■Form 5b, Direct-Line Console (DLC)—Digital

■Form 5c, MFM Adjunct—DLC

■Form 5d, Queued Call Console (QCC)

Connecting the Network Interface

The following forms indicate the trunks that are to be connected to the control

unit. Information regarding the channel service unit is indicated as well. This - information is needed to perform the procedures in Chapter 4.

1-4System Forms