Initializing and Testing the System

NOTE:

If you are upgrading from the MERLIN II Communications System, see “Upgrading from the MERLIN II Communications System”earlier in this chapter.

1.Lay the front panel(s) face down.

2.If more than one carrier is being housed, connect the front panels together by lining up the arrows and then sliding the panels until the semicircles form a complete circle (as shown in Figure 7-2).

3.Connect the side panels to the front panel(s) similarly.

4.Pick up the whole housing and place it on the control unit.

NOTE:

If the system has more than one carrier, make sure you hold the housing only from the basic carrier side. Otherwise, the housing will disassemble.

a . Line up the wire clips that are attached to the carrier with the recesses on the outside of the side panels.

NOTE:

If the wire clips are not already attached to both sides of the control unit, see “Installing the Housing Clips” in Chapter 2.

b . Push back the panels until the clips hook over the tabs and rest in the recesses.

Installing the Control Unit Housing 7-33

Page 310
Image 310
AT&T Release 2.0 manual