Installation, Portsmouth | American Standard 7420.9

To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.	CertiÞed to comply with ANSI A112.18.1M
	M965027 REV. 1. 6

Recommended Tools

Flat Blade Screwdriver

Adjustable Wrench

Tubing Cutter

*Wrench

Channel Locks	*Hex key
	*Supplied with Fitting

1	SPOUT ASSEMBLY CAUTION		Turn off hot and cold water	2 PREPARE TUBE AND TEE ASSEMBLY
1	SPOUT ASSEMBLY CAUTION		supplies before beginning.	2 PREPARE TUBE AND TEE ASSEMBLY
	Install RUBBER RING (1) into recess of spout base.			Prepare TUBE and TEE ASSEMBLY (1) to Þt center to center
	Insert SPOUT SHANK (2) through center hole of MOUNTING LEDGE.			VALVE (2) location (between 6-1/2" and 12"). If necessary,
				cut and/or bend TUBING carefully. Make sure tube bend is
	Make sure that the RUBBER RING (1) is properly seated in RECESS			close to the TEE (1) so that it will not effect the compression
	of SPOUT BASE.			joint at the VALVE CONNECTION.
	Assemble RUBBER WASHER (3) and BRASS WASHER (4) onto			Remove COUPLING NUT (3) and FERRULE (4) from each
	SHANK (2). From underside of ledge secure SPOUT (6) into position			Remove COUPLING NUT (3) and FERRULE (4) from each
				VALVE (2) and slide onto TUBING (5).
	with LOCKNUT (5).			VALVE (2) and slide onto TUBING (5).
	with LOCKNUT (5).			4
				4	3
					1
					5
			6	6-1/2" to 12"	3	4
			6	6-1/2" to 12"
				(165mm to 305mm)
	2	RECESS
		RECESS