INSTALLATION AND FRAMING INSTRUCTIONS
The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs as required. Ensure
NOTE: The apron should not be used as the primary access opening.
1.Position the whirlpool into the installation opening and level the deck, shimming the integral support feet as necessary. Mark the final position of the underside of the deck by tracing a line on to the studs (see Figure 1).
2.Remove the whirlpool and attach a 2 x 4 stringer to the studs, with the top of the stringer touching the traced line.
3.Install drain components to the whirlpool following the manufacturers instructions. Before replacing your whirlpool for final installation, be certain that an opening has been provided in the
4.Replace whirlpool and
FIG. 1
495mm
TILE |
BEAD |
STRIP |
TILE
WALLBOARD
SEALANT
BATH
ADHESIVE
LEVELING
STRINGER
NOTE: Tile bead kit not included and must be purchased separately.
TYPICAL INSTALLATION
TRACED OUTLINE
CUTOUT *
(495mm)
WHIRLPOOL
ACCESS
PANEL
*SEE CUTOUT TEMPLATE PROVIDED. FOR UNITS WITH OPTIONAL APRON PANEL, SEE APRON INSTALLATION INSTRUCTION
UNLESS AN ACCESS OPENING OF AT LEAST 12" X 24" (305 X 610MM) IS PROVIDED, WARRANTY SERVICE WILL NOT BE PERFORMED.
(2) SPIC AND SPAN® IS A REGISTERED TRADEMARK OF PROCTER & GAMBLE |