American Standard 7871.702, 7881.722, 7881.732 Test Installed Fitting, Check Drain Connections

10	INSTALL HANDLES (Lever)	4	INSTALL HANDLES (Cross)	4	4
Turn VALVE into OFF position.			Turn VALVE into OFF position.		3
		3	Push ADAPTER (1) into HANDLE	6
Push ADAPTER (1) into HANDLE		6	BASE (2) in a way that the male		7
BASE (2) in a way that the male			square on the ADAPTER (1) fits	3
square on the ADAPTER (1) fits			in the female square of the
in the female square of the			HANDLE BASE (2).
HANDLE BASE (2).		2	Push HANDLE BASE (2) and	2
Push HANDLE BASE (2) and					WASHER
			ADAPTER (1) onto VALVE STEM (5).		(PORCELIAN
ADAPTER (1) onto VALVE STEM (5).		1			CROSS
			Check alignment, if not satisfactory	1	HANDLE ONLY)
Check alignment, if not satisfactory
			aligned;
aligned;		5	Push out ADAPTER (1) carefully.	5
	Push out ADAPTER (1) carefully.
			Turn ADAPTER (1) either 45˚ or 90˚
	Turn ADAPTER (1) either 45˚ or 90˚		so that male square on ADAPTER
	so that male square on ADAPTER (1)		(1) catches different female square
	catches different female square in		in HANDLE BASE (2).
	HANDLE BASE (2).		Secure HANDLE BASE (2) and METAL
Secure HANDLE BASE (2) with HANDLE SCREW (3).			CROSS (6) or PORCELAIN CROSS (7) with HANDLE SCREW (3).
Push INDEX CAP (4) in hole of LEVER BALL (6).			Push INDEX CAP (4) in hole of METAL CROSS (6) or
			PORCELAIN CROSS (7).
11 TEST INSTALLED FITTING			5		1
With HANDLES (1) in OFF position, turn on WATER					3
SUPPLIES (2) and check all connections for leaks.

Remove AERATOR (3).

Operate both HANDLES (1) to flush water lines thoroughly.

Replace AERATOR (3).

1

4

12 CHECK DRAIN CONNECTIONS

Operate POP-UP KNOB (5) and fill Sink with water. Check that DRAIN STOPPER (4) makes a good seal and retains water in Sink. If STOPPER (4) does not seal properly, please refer to “Troubleshooting Guide” in these instructions.

Release POP-UP KNOB (5) down and check all drain connections and "P" trap for leaks. Tighten

if necessary.

WASTE

OUTLET

2

COLD

“P” TRAP

2

HOT

13 CARE INSTRUCTIONS:

DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER.DRY WITH A SOFT COTTON FLANNEL CLOTH.

DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH A COARSE SURFACE.

14 SERVICE		1
		2
To change direction of handle rotation, proceed as follows:		3
Turn valve to OFF position.
Remove IINDEX (1) and HANDLE SCREW (2).	90˚
Pull HANDLE (3) off.
Remove ADAPTER (4).
Remove SPRING CLIP (5).	7
Lift STOP WASHER (6), turn 90˚ and replace.	5	4
Replace SPRING CLIP (5).

Replace ADAPTER (4), HANDLE (2),

SCREW (2), and INDEX (1).

If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90˚.

U S 6 0 4 0 4 R e v. 1 . 2

4